How to Replace Your Sink

kitchen sink

How to Replace Your Sink

Trying to replace a sink can be a big job. If you have a fairly standard drop-in or under-mount sink, then the replacement process may be somewhat easier to complete.

However, it is worth noting that any time you end up connecting and disconnecting piping, there is a chance that leaking or flooding may occur. So, if you’re not comfortable with that, you may want to bring in a professional.

kitchen sink

Curious about how to treat a stubborn clog?


How to Replace a Sink

If you think you can tackle this, here are some tips:

  1. Turn off the water supply

It sounds obvious, but…before you begin taking things apart, make sure to turn off the water. Proceed to run the faucet to release any pressurized water left in the pipes. Once this is done, place a bucket beneath the p-trap pipe (the pipe beneath the sink that curves) and remove it. Water may flow into the bucket at this point.

  1. Loosen the supply lines to the sink

You will need to use a wrench to loosen and disconnect the water supply lines from the sink. Have another bucket ready in the event of a water leak.

  1. Remove the sink

Now that the pipes are disconnected, it’s time to remove the sink. Be sure to have a utility knife at the ready, as you will need to cut open the sealant at the back of the sink to separate it from the wall.

Once the sealant has been cut, you can simply pull the sink free from the wall. Remove any other parts of the sink from the vanity or countertop base, including the sink top, if it hasn’t already come off.

Now that the old sink has successfully been removed, it’s time to install the new one.

  1. Connect the faucet and drain

First, connect the faucet and drain to the new sink. Once the faucet and drain have been attached to the sink, proceed to apply silicone adhesive to the rim/backing of the vanity or countertop the sink will be resting in.

  1. Lay in the new sink

Once the adhesive has been applied, find somebody else to help you set the sink into the countertop/vanity.  It is essential everything is lined up properly when the sink is laid in. Now, wait until the adhesive has cured and sealed the sink.

  1. Reattach the piping

Once the sink has been attached to the vanity/countertop, reattach all of the piping. You may need to cut the new drainpipe on the sink to a shorter length, so everything fits properly. Make sure all of the water supply pipes and valves have been reconnected properly.

  1. Caulk the sink

After reconnecting the piping, caulk the sink onto the countertop or vanity. You may need to clean excess caulking.

  1. Test and adjustment

Finally, you can turn the water back on and make sure everything seems to be running in proper order. This is the right time to make small adjustments, especially with piping connections. Once everything is functioning, your job is done, and you’ve successfully installed a new sink.

Congratulate yourself on a great job!

Need assistance with replacing a sink? Contact the experts at Agentis. We’re ready to help.

Want us to help? Get an

Top